Custom Cabinets for Round Rock, TX homeowners

Does your kitchen still have the cabinets the builder put in twenty years ago? Round Rock has that kind of range. Neighborhoods built decades back sit near subdivisions still going up on the west side. Round Rock Custom Cabinets works both ends of that spectrum.

The city splits along the Balcones Escarpment. East of I-35, lots sit on flatter Blackland Prairie clay. That soil swells and shrinks with the seasons, and older homes built on it often show it: cabinet doors that rub, gaps at the ceiling line, drawers that stick in summer and loosen in winter.

West of the highway, the ground turns hillier and rockier, part of the Hill Country edge. Houses there tend to hold their lines better but still need cabinetry sized to the actual room, not a catalog width.

That matters because a stock box from a home center assumes a square opening. A lot of Round Rock kitchens, especially the older ones, don’t have one anymore. We measure what’s actually there, out-of-square walls and all, and build to match it.

Serving Homeowners in Round Rock

Round Rock’s population crossed 140,000 in recent counts, part of the wider Austin metro, and the housing mix reflects that growth. Original-owner homes from the 80s and 90s sit next to new construction still smelling of fresh drywall. Each needs a different conversation.

In the older, established pockets, especially east of I-35, we see a lot of requests to reface cabinets that are structurally fine but dated. Sometimes we rebuild a kitchen where foundation movement has thrown the cabinet lines out of alignment. In newer west-side builds, the ask is usually full custom from the start: pantries, home bars, garage storage, closets sized for a growing household.

We also work in Wells Branch, right on Round Rock’s edge, where cabinet refacing and closet upgrades are a common, practical choice for established subdivisions. If you’re not sure which category your project falls into, that’s a fine thing to figure out on the phone.

Custom Cabinets FAQs for Round Rock

How much do custom cabinets cost in Round Rock? It depends on scope. A reface job for one kitchen’s worth of doors and drawer fronts runs a few thousand dollars. A full custom kitchen rebuild, new boxes, doors, and hardware throughout, climbs higher based on linear footage, wood species, and finish. We give a written number after measuring, not a phone-quote guess.

Do I need a permit for cabinet work in Round Rock? Straight replacement or refacing, no. If the project moves plumbing or electrical, like relocating a sink or adding outlets behind a bar, that typically does require a permit. We’ll flag it before work starts, but check with the city or county for your specific scope.

My cabinet doors don’t close right anymore. Is that a foundation issue? Often, yes, especially in older homes east of I-35 where clay soil shifts seasonally. Walls move slightly, cabinet boxes rack out of square, and doors stop sealing. A pro can rebuild the box square to the new wall line instead of just rehanging the same door.

How far ahead should I book before a kitchen remodel? Order your cabinets before you schedule the rest of the remodel. Fabrication alone runs several weeks once a design is approved, so lock in cabinets first and build the rest of your timeline around that.

Request a Free Estimate in Round Rock

Ready to see what your project costs? Call Round Rock Custom Cabinets or request a free estimate. We also build for Wells Branch and the rest of the service area listed on Home.